31 00... Front Axle and Steering: Wheel/Chassis Alignment Check Must Be Carried Out After The Following Work
A wheel/chassis alignment check must be carried out after the following work: See KDS WHEEL ALIGNMENT WITH VEHICLE LOAD UP TO DESIGN POSITION or KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD
- Release of following screw/bolt connections:
- Steering gear to front axle carrier.
- Lower wishbone to front axle support.
- Track rod end to track rod.
- Replacement of following parts:
- Front axle support
- Steering gear
- Swivel bearing
- Track rod end
- Lower control arm/rubber mount
- Track rod
- Gaiter (if the tie rod end has to be screwed off)