41 00... Pasting Reinforcement Plate On Drive Module
In the case of a partial replacement piece, a body component is cut at a point described in the repair instructions.
A reinforcement plate is bonded in to ensure sufficient strength.
Observe notes on REPAIR STAGE 2 .
NOTE:
The following graphics serve as general illustrations of reinforcement plate repair work. They apply to sectional repairs on the carbon side frame.
Mark component in accordance with dimension a and cut.
Preparation:
Cut new part (1) in accordance with cut on vehicle and if necessary adjust to fit with set of attachments or universal mount.
PREPARE surface of reinforcement plate (1) and body.
Installation
Apply adhesive (1) to reinforcement plate bonding surface.
Carefully slide reinforcement plate half-way into body component (2).
IMPORTANT:
When joining reinforcement plate, make sure there is sufficient adhesive on bonding surfaces.
Apply adhesive (1) to reinforcement plate bonding surface.