61 34... Removing and installing/replacing 12-V power socket

Special tools required :

Necessary preliminary tasks :

Check the equipment dependent sockets that are available.

Cup holder :

Unclip connector (1) and feed through under center console to power socket (2).

Remove power socket (2) using special tool 61 0 250 .

See last operation.

Fig 1: Identifying Power Socket Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Rear center console trim :

Remove socket (1) from the center console trim using special tool 61 0 250 .

See last operation.

Fig 2: Identifying Socket And Rear Center Console Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment :

Hold the left luggage compartment wheel arch panel from behind and disconnect the connector (1) from the power socket (2).

Fig 3: Identifying Power Socket Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment :

Fold up the protective cap over power socket (1).

Fig 4: Identifying Power Socket Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment :

Remove socket (1) using special tool 61 0 250 .

See last operation.

Fig 5: Identifying Socket

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out 12-V power socket from housing with special tool 61 0 250 until connector is at bottom of light ring.

Fig 6: Removing 12V Socket Using Special Tool (61 0 250)

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Graphic similar

Lever out power socket (1) in direction of arrow with a suitable tool.

Fig 7: Removing Power Socket

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanisms (1) with a suitable tool.

Press power socket mounting (2) in direction of arrow out of power socket frame (3).

Installation note :

Latch mechanisms (1) at socket mounting (2) must not be damaged. Make sure socket mounting (2) is fitted correctly in socket frame (3).

Fig 8: Releasing Latch Mechanisms

Courtesy of BMW OF NORTH AMERICA, INC.