12 51 240 Remove and install/replace Module 2, sensor system engine wiring: Notes

Preliminary work 

• Refer to REMOVING THE ACOUSTIC COVER
• Remove the cover in the left engine compartment
• Remove the right cover in the engine compartment
• Refer to REMOVING TRAILING LINK AT SPRING STRUT DOME
• Remove the sound insulation on the bulkhead upper part at the center
• Refer to REMOVING ACOUSTIC COVER AT REAR
• Refer to REMOVING INTAKE SILENCER HOUSING
• Refer to REMOVING CLEAN AIR PIPE
• Refer to REMOVE CHARGE AIR LINE
• Refer to UNINSTALL COVER FOR THE DME CONTROL UNIT 
• Refer to DISCONNECTING CONNECTOR FROM DME CONTROL UNIT AND FROM POWER DISTRIBUTION MODULE (PDM) 

Follow-up work 

• Refer to CONNECT THE CONNECTOR TO THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM) 
• Refer to INSTALL COVER FOR THE DME CONTROL UNIT 
• Refer to INSTALL CHARGE AIR LINE
• Refer to INSTALLING CLEAN AIR PIPE
• Refer to INSTALLING INTAKE SILENCER HOUSING
• Refer to INSTALLING ACOUSTIC COVER AT REAR
• Install the sound insulation on the bulkhead upper part at the center
• Install tension strut on spring strut dome. Jointing torque: 56 Nm, angle of rotation: 90°
  NOTE: Replace screws.
• Install the cover in the engine compartment on the left
• Install the cover in the engine compartment on the right
• Refer to INSTALL ACOUSTIC COVER