Installing the Basic Central Platform (BCP) control unit
WARNING:
Work on components with requirements for a secure energy supply.
Ensure proper function after a repair.
Ensure proper function after a repair.
- Lines are allowed to have only one repair area.
- Notices in the diagnostic system circuit diagrams must be observed.
NOTES ON THE CONTENT AND HANDLING OF DIAGNOSIS INFORMATION .
- When components are replaced, any relevant notes in the BMW parts catalogue must be observed.
- Position the Basic Central Platform (BCP) control unit (2) and push it into the holder (3) until the lock (1) locks.
- Connect all connectors and lock.
- Position cover (3) properly and engage it into the lock (2) .
- Fasten the cable clip (1) .
Follow-up work
- Refer to POSITIONING THE CARPET IN THE FOOTWELL ON THE RIGHT .
- Refer to INSTALLING DOOR SILL COVER STRIP, FRONT RIGHT .
- Refer to INSTALLING THE CENTER RIGHT A-PILLAR TRIM PANEL .
- Refer to INSTALLING THE SIDE PANEL ON DASHBOARD ON THE RIGHT .
- Refer to INSTALLING THE CENTER STACK TRIM .
- Refer to INSTALLING RIGHT FOOTWELL TRIM .
- Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
- Refer to INSTALLING THE BOTTOM FRONT CENTER CONSOLE .
- Refer to INSTALLING THE STORAGE TRAY FOR THE NEAR FIELD COMMUNICATION .
- Refer to ACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .