Installing the telematics control module

• Connect the connector (1)  with the telematics control module (2) 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide in the telematics control module (1)  and position it correctly

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: To provide a better overview: Illustration of surrounding parts removed
• Attach the telematics control module (1)  to the roof antenna (4) 
• Press the telematics control module (1)  forward slightly so that the guides (2)  align with the guides (3)  . While doing so, press in the locking pin (5)  so that it is flat and position the telematics control module (1) 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Pull the telematics control module (1)  in the arrow direction using the special tool 0 494 365 (51 3 252) until the interlock (2) locks correctly 
• Ensure the correct fit of the telematics control module (1) 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the clips (1)  correctly and clip them in

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (1) 
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Interference suppression filter to body
  Screw	tightening torque	3 Nm

• Tighten down screw (2) 
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Antenna amplifier to body
  Screw	tightening torque	2.50 Nm

• Connect connector (3) 
• Fasten the cable clip (4) 

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to TRIM OF THE 3RD INSTALLING THE BRAKE LIGHT .
• Refer to INSTALLING THE HEAD RESTRAINT AT THE REAR CENTER .
• Refer to RECONNECTING ALL BATTERY GROUND LEADS .
• Refer to ENCODING/PROGRAMING CONTROL UNIT(S) .