(Program/encode the VDP control unit)
Encode/program control unit(s)
Precondition
Component has been replaced
NOTE:
TECHNICAL INFORMATION
Use the most recent software version to prevent faults during programming/coding
The battery voltage must not fall below 13.0 V during programming
Use only chargers for a low volt-vehicle electrical system that are recommended by BMW
Use the most recent software version to prevent faults during programming/coding
The battery voltage must not fall below 13.0 V during programming
Use only chargers for a low volt-vehicle electrical system that are recommended by BMW
NOTE:
TECHNICAL INFORMATION
No high-voltage switch off is required in electric vehicles or hybrid vehicles for programming/coding
The high-voltage system will be automatically switched off by the programming system
No high-voltage switch off is required in electric vehicles or hybrid vehicles for programming/coding
The high-voltage system will be automatically switched off by the programming system
- Connect the battery charger to the vehicle
- Connect the programming system with the vehicle
- Determine the action plan
- Accept and fully process the action plan
- Depending on the reworking list, connect the workshop system to the vehicle if necessary
- Carry out vehicle test
- Delete the fault memory
- Observe the information on programming in the workshop system and the relevant notes in the user documentation
- Wait until programming/coding has been completed
- Disconnect the programming system from the vehicle
- Disconnect the battery charger from the vehicle