Computer Command Control - Port Fuel Injection

Typical Ignition Module Assembly:

REMOVE OR DISCONNECT:

1. Negative battery cable.
2. DIS Electrical connector.
3. Spark plug wires. (Note wire positions to proper coils).
4. DIS assembly to block.
5. DIS assembly from engine.

INSTALL OR CONNECT:

1. DIS assembly from engine.
2. Spark plug wires to proper coils.
3. DIS Electrical connector.
4. Negative battery cable.
5. Before starting engine perform IDLE LEARN PROCEDURE. Refer to ADJUSTMENT PROCEDURES/IDLE LEARN PROCEDURE.