Ignition Control Module: Service and Repair

Dielectric Grease Application:

Typical Ignition Module Assembly:

REMOVAL

1. Disconnect negative battery cable.
2. Disconnect DIS electrical connectors.
3. Disconnect spark plug wires. (Note proper relationship of wires to coils).
4. Remove DIS assembly to block bolts (3).
5. Remove DIS assembly from engine.



INSTALLATION

1. Install DIS assembly to engine.
2. Install DIS assembly to block bolts (3). Torque to 20-30 Nm (15-22 ft lb).
3. Connect spark plug wires to proper coils.
4. Connect DIS electrical connectors.
5. Connect negative battery cable.