Electronic Brake Control Module/Electronic Brake & Traction Control Module (EBCM/EBTCM) & Brake Pressure Modulator Valve (BPMV) Assembly: Installation

1. To install, reverse removal procedure. Ensure brakelines are installed in original locations. Ensure EBCM/EBTCM electrical connector tab is locked down. Tighten bolts, nuts and brakelines to specification. See TORQUE SPECIFICATIONS  .
2. If NEW BPMV assembly is being installed, ensure shipping plugs are removed from valve openings. Refill brake master cylinder reservoir, bleed brakes and check for leaks. See BLEEDING BRAKE SYSTEM  .
3. Using scan tool, perform DIAGNOSTIC SYSTEM CHECK  . Check for any Diagnostic Trouble Codes (DTCs) that have been set. Diagnose and repair as necessary.

Fig 1: Removing EBCM/EBTCM & BPMV Assembly

Courtesy of GENERAL MOTORS CORP.

Fig 2: Separating EBCM/EBTCM From BPMV Assembly

Courtesy of GENERAL MOTORS CORP.