Electronic Brake Control Module: Installation

WARNING: This page is about a different car, the 2001 Pontiac Grand Prix, 2001 Pontiac Firebird, 2001 Oldsmobile Intrigue, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

To install, clean BPMV gasket surface with alcohol. Install NEW wave spring(s) in original location and position between EBCM and BPMV. Install EBCM to BPMV. Install 4 NEW top mounting screws and tighten in an "X" pattern. Install 2 NEW bottom screws and tighten. See TORQUE SPECIFICATIONS .
Connect pump motor connector at bottom of EBCM. Connect EBCM harness connector and push in lock tab. Turn ignition on, with engine off. Perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING.