LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2000 >> LeSabre Limited, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Engine Controls - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
  2. Remove the drive belt. Refer to Drive Belt Replacement (L36) in Engine Mechanical.
    3. Fig 1: Disconnecting/Reconnecting Electrical Connector To CMP Sensor
    GM389047Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector (2) from the camshaft position sensor (1).
    4. Fig 2: Removing/Installing Camshaft Position (CMP) Sensor
    GM12305Courtesy of GENERAL MOTORS CORP.
  4. Remove the camshaft position (CMP) sensor retaining screw.
  5. Remove the CMP sensor from the engine front cover.
scientia non olet · About LEMON Manuals