LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2002 >> Century Custom >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle Servicing >> Removal & Installation >> Case Side Cover >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Case Side Cover: Installation

  1. Install the case side cover gasket (54). See Figure . Install the case side cover pan (53). Install the case side cover bolts (56-58). Tighten case side cover bolts to specification. See TORQUE SPECIFICATIONS  .
  2. Remove the drain pan from under the transaxle. Adjust the jackstand to raise the left side of the frame. Install the left and right side frame bolts.
  3. Install the engine mount lower nuts. Install the transaxle mount. See TRANSAXLE MOUNT  . Remove the jackstands from the frame. Install the 3-way catalytic converter pipe to the right exhaust manifold.
    4. CAUTION: When installing the intermediate shaft make sure that the shaft is seated prior to pinch bolt installation. If the pinch bolt is inserted into the coupling before shaft installation, the two mating shafts may disengage. Disengagement of the two mating shafts will cause loss of steering control which could result in personal injury.
  4. Install the intermediate shaft to the steering gear and the pinch bolt. See appropriate POWER RACK & PINION article in STEERING. Install the left drive axle to the transaxle. See appropriate article in DRIVE AXLES. Lower the vehicle. Connect the transaxle wiring harness connector.
  5. Install the engine mount struts. See appropriate REMOVAL & INSTALLATION article. Remove the engine support fixture. Install the throttle body air inlet duct. Connect the negative battery cable.
  6. DO NOT overfill the transaxle. Overfilling will result in foaming, loss of fluid, and possible damage to the transaxle. Fill transaxle with appropriate fluid to proper level. See LUBRICATION  . Inspect for fluid leaks.
scientia non olet · About LEMON Manuals