PASS-Key II - Adding Keys

ADDING KEYS

TOOLS REQUIRED
J 35628-A Vats/Pass Interrogator Tester

1. In order to copy a PASS-Key II ignition key, determine the necessary key code or resistance value.

IMPORTANT: When servicing the PASS-Key II system, obtain all the vehicle ignition keys. Verify the key code values with the J 35628-A.

2. Determine the master ignition key code using the J 35628-A as outlined in the following procedure:
2.1. Turn ON the J 35628-A.

IMPORTANT: Disconnect the tool wiring connectors.

2.2. Insert the key into the tool lock cylinder.
2.3. Note the measured key code of the master ignition key as displayed on the key code reader.
2.4. Obtain a key blank matching the key code.
2.5. Cut the key blank to match the original key.