Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of MAF Sensor

Courtesy of GENERAL MOTORS CORP.

Install the MAF sensor (1).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the MAF sensor screws (9).
Tighten: Tighten the screws to 3 N.m (27 lb in).
Connect the MAF sensor electrical connector (8).
Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67) in Engine Mechanical - 3.8L.