Specifications Index
CENTURY SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REFRIGERANT SYSTEM CAPACITIES | ||
| Torque | |||
| Automatic | FASTENER TIGHTENING SPECIFICATIONS | ||
| Manual | FASTENER TIGHTENING SPECIFICATIONS | ||
| Axle Nut/Hub Nut | 118 Ft. Lbs. (160 N.m) | ||
| Battery | BATTERY USAGE | ||
| Brakes | |||
| Bleeding Sequence | RR, LF, LR, RF | ||
| Disc Brakes | DISC BRAKE COMPONENT SPECIFICATIONS | ||
| Drum Brakes | NA | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERATOR USAGE | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | NA | ||
| Belt Routing | See appropriate figure under DRIVE BELT REPLACEMENT | ||
| Engine Cooling | |||
| General Service Specifications | SPECIFICATIONS | ||
| Radiator Cap Pressure | Rated pressure is stamped on cap. | ||
| Thermostat R & I | WATER OUTLET AND THERMOSTAT REMOVAL | ||
| Water Pump R & I | WATER PUMP REMOVAL | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION TEST | ||
| Oil Pressure | 60 psi (414 kPa) at 1850 RPM | ||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive PlateTorque | 51 Ft. Lbs. (71 N.m) | ||
| Fuel System | |||
| Pressure Specification | 52-59 psi (358-405 kPa) | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM DIAGNOSIS | ||
| Fuel Filter Location | See FUEL FILTER REPLACEMENT . | ||
| Fuel Filter R & I | FUEL FILTER REPLACEMENT | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | 3,000 Ohms per ft. (9,000 Ohms per meter) | ||
| Ignition Wires (Routing) | See figure under SPARK PLUG WIRE REPLACEMENT | ||
| Spark Plug | |||
| Type | 41-940 | ||
| Gap | .060 In. (1.52 mm) | ||
| Torque | Tighten the spark plugs to 20 lb ft (27 N.m) when installing spark plugs into a new cylinder head. Tighten the spark plugs to 11 lb ft (15 N.m) when re-installing after initial installation. |
||
| Starting | |||
| Starter | STARTING SYSTEM DESCRIPTION AND OPERATION | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (140 N.m) | ||