LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2007 >> Rendezvous CX >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System >> Repair Instructions >> Object Alarm Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Rear Object Alarm Detection Module
    GM785378Courtesy of GENERAL MOTORS CORP.
  1. Install the rear object alarm detection module.
  2. Install the electrical connector to the module.
    3. NOTE: Refer to Fastener Notice .
  3. Install the bolts that secure the rear object alarm detection module.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Secure the top of the quarter trim over the bolts.
    5. Fig 2: Identifying Rear Liftgate Sill
    GM786746Courtesy of GENERAL MOTORS CORP.
  5. Install the cargo tie-down loops from the rear quarter trim.
  6. Install the rear liftgate sill.
  7. Install the storage compartment. Refer to Storage Compartment Replacement - Rear (Rendezvous) .
    8. Fig 3: View Of Upper Trim From Second & Third Row Pillars
    GM786752Courtesy of GENERAL MOTORS CORP.
  8. Install the upper trim from the second and third row pillars.
    9. Fig 4: Locating Guide Loop Bolt
    GM786753Courtesy of GENERAL MOTORS CORP.
  9. Install the guide loop bolts from the second and from the third row seat belts.
    10. Fig 5: Identifying Guide Loop Covers From LH Rear Seat Belt
    GM786759Courtesy of GENERAL MOTORS CORP.
  10. Close the guide loop covers to the left rear seat belt.
    11. Fig 6: Aligning Second Row Seats Forward
    GM786757Courtesy of GENERAL MOTORS CORP.
  11. Return the second and the third row seats to their upright positions.
  12. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals