LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2012 >> Regal Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (Programming And Setup - All Systems) >> Repair Instructions >> Electronic Suspension Control Module Programming and Setup >> Suspension Control Module Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Suspension Control Module Programming

WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

To program and setup an existing or new replacement suspension control module, perform the following procedure:

  1. With a scan tool, access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) .
  2. On the SPS Supported Controllers screen, select ESCM Electronic Suspension Control Module - Programming and follow the on-screen instructions.

If the suspension control module fails to accept the program, verify all scan tool and suspension control module connections are secure.

NOTE: After programming is completed, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. With a scan tool, clear all DTCs from all modules.
scientia non olet · About LEMON Manuals