LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2012 >> Regal Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Power Door Lock System And Release Systems) >> Diagnostic Information and Procedures >> Trunk Release Malfunction >> Circuit/System Testing >> Trunk Release Switch Inoperative
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Trunk Release Switch Inoperative

WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the S58A rear compartment lid unlatch switch-exterior.
  2. Ignition ON, test for less than 10 Ω between the ground circuit terminal 2 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Verify the scan tool Interior Trunk Lid/Liftgate Window Unlatch Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 1 for a short to ground. If the circuit tests normal, replace the K9 BCM.
  4. Install a 3 A fused jumper wire between the signal circuit terminal 1 and ground. Verify the scan tool Interior Trunk Lid/Liftgate Window Unlatch Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9 BCM.
  5. If all circuits test normal, test or replace the S58A rear compartment lid unlatch switch-exterior.
scientia non olet · About LEMON Manuals