Replace and Program EBCM or Reprogram EBCM

To program a replacement or an existing EBCM, perform the following procedure:

1. Install EL-49642  SPS programming support tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select Electronic Brake Control Module-Programming and follow the on-screen instructions.
4. On the SPS Supported Controllers screen, select Electronic Brake Control Module-Setup and follow the on-screen instructions.
5. On the SPS Supported Controllers screen, select Electronic Brake Control Module-Configuration and follow the on-screen instructions.
6. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
7. With a scan tool access the Electronic Brake Control Module, Configuration/Reset Functions, Brake Pressure Sensor Calibration. Refer to Brake Pressure Modulator Valve Pressure Sensor Calibration .
8. With a scan tool, access the Electronic Brake Control Module, Configuration/Reset Functions, Yaw Rate Sensor Learn. Refer to Vehicle Yaw Sensor Learn .
9. With a scan tool, access the Electronic Brake Control Module, Configuration/Reset Functions, Steering Wheel Angle Sensor Learn. Refer to Steering Angle Sensor Centering .