Inflatable Restraint Roof Side Rail Module Replacement - Front

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Inflatable Restraint Roof Rail Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . WARNING: Refer to SIR Inflator Module Handling and Storage Warning . WARNING: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS. WARNING: When installing the roof rail airbag, do not twist or turn the airbag 360 degrees. Securing the roof rail airbag with an airbag twisted or turned 360 degrees may cause the airbag not to deploy correctly and could cause personal injury. Preliminary Procedures Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling . Remove the headliner. Refer to Headlining Trim Panel Replacement .
1	Inflatable Restraint Roof Rail Module Screw CAUTION: Refer to Fastener Caution . Tighten: 8 N.m (71 lb in)
2	Inflatable Restraint Roof Rail Module Bolt Tighten: 8 N.m (71 lb in)
3	Inflatable Restraint Roof Rail Module Bolt Tighten: 8 N.m (71 lb in)
4	Inflatable Restraint Roof Rail Module Retainer (Qty: 3)
5	Inflatable Restraint Roof Rail Module Bolt Tighten: 8 N.m (71 lb in)
6	Inflatable Restraint Roof Rail Module Assembly Procedure Remove the connector position assurance (CPA) retainer. Disconnect the electrical connector.