LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2015 >> Regal GS, FWD, Automatic Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> Heated Seat Control Module Programming and Setup >> Seat Heating Control Module Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Seat Heating Control Module Programming

To program and setup an existing or new replacement seat heating control module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the onscreen instructions. Refer to Service Programming System (SPS) Description .
  2. On the SPS Supported Controllers screen, select HVSMF Front Seat Heating Control Module Programming and follow the onscreen instructions.

If the HVSMF Front Seat Heating Control Module fails to accept the program, verify all scan tool and seat heating control module connections are secure.

NOTE:

After programming is completed, perform the following to avoid future misdiagnosis:

  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. Clear all DTCs from all modules.
scientia non olet · About LEMON Manuals