LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2016 >> Encore Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Programming And Setup - All Systems) >> Repair Instructions >> K20 Engine Control Module: Programming and Setup >> Reprogram Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reprogram Control Module

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

To reprogram an existing K20 Engine Control Module, perform the following procedure:

  1. Install EL-49642  SPS programming support tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. Clear DTCs after completing the Programming procedure.
    4. NOTE:

    If vehicle fails to start during Configuration and Setup, perform the SPS Function Immobilizer Learn and follow the on-screen instructions.

  4. Perform the SPS function Engine Control Module - Configuration & Setup and follow the on-screen instructions, if available.
  5. Clear DTCs after completing the Configuration & Setup procedure.
scientia non olet · About LEMON Manuals