CAN Graphical Interface (CGI) Circuit Description
This bus is used by the Entertainment sub-system to transfer high-rate display graphics between the A11 Radio and the P17 Info Display Module and/or Radio/HVAC Control. The electrical characteristics of the CAN Graphical Interface (CGI) Bus are very similar to the High Speed GMLAN Bus. The message strategy and construction of messages are different however. Sometimes communication is required between the CAN Graphical Interface Bus and the Low Speed GMLAN Bus. This is accomplished by using the A11 Radio as the Gateway module. Since the CAN Graphical Interface Bus and primary High Speed GMLAN Bus have similar electrical characteristics, the diagnostics for each are similar.
In the case where the P17 Info Display Module and Radio/HVAC Control are separate devices the P17 Info Display Module is responsible for passing information between the A11 Radio and the Radio/HVAC Control. The A11 Radio interfaces only with the P17 Info Display Module and the P17 Info Display Module then communicates with the Radio/HVAC Control through a Local Interconnect Network (LIN) interface.
A bus wake up signal will be generated by the A11 Radio or by the P17 Info Display Module when the system functionality is required. The communication function of the CAN Graphical Interface shall be enabled or disabled based on the voltage level of the Center Stack Wake. The network will stay awake as long as the circuit voltage is driven low, to less than 1.5 V. Communications are disabled with a high circuit voltage around 5.0 V.
The A11 Radio can execute a warm reset of the P17 Info Display Module if the P17 Info Display Module fails to respond to the A11 Radio's request. The Center Stack Reset is a low-asserted pull down output (less than 1.5 V) from the A11 Radio to the P17 Info Display Module and has the same electrical characteristics as those for the Center Stack Wake signal defined above.