Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Control Arm to Steering Knuckle Bolt and Nut | |
|
115 N.m (85 lb ft) |
|
120-135 degrees |
| Front Stabilizer Shaft Insulator Clamp Bolt | |
|
22 N.m (16 lb ft) |
|
30-45 degrees |
| Front Wheel Hub to Steering Knuckle Bolt | |
|
90 N.m (66 lb ft) |
|
60-75 degrees |
| Lower Control Arm to Subframe Bolt and Nut - Front | |
|
70 N.m (52 lb ft) |
|
75-90 degrees |
| Lower Control Arm to Subframe Bolt and Nut - Rear | |
|
70 N.m (52 lb ft) |
|
75-90 degrees |
| Rear Control Arm Bushing to Control Arm Bolt | |
|
55 N.m (41 lb ft) |
|
45-60 degrees |
| Stabilizer Shaft Link Nut | 65 N.m (48 lb ft) |
| Steering Knuckle Lower Camber Adjust Bolt and Nut | |
|
115 N.m (85 lb ft) |
|
45-60 degrees |
| Steering Knuckle Upper Camber Adjust Bolt and Nut | |
|
70 N.m (52 lb ft) |
|
45-60 degrees |
| Steering Knuckle to Upper Ball Stud Nut | |
|
45 N.m (33 lb ft) |
|
30 degrees |
|
15 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Shock Absorber Yoke Bolt and Nut | 70 N.m (52 lb ft) |
| Front Suspension Strut Mount Nut | 45 N.m (33 lb ft) |
| Steering Gear Outer Tie Rod to Steering Knuckle Nut | 35 N.m (26 lb ft) |
| Steering Knuckle King Pin Bolt | 7 N.m (62 lb in) |
| Steering Knuckle King Pin Bushing Nut | 70 N.m (52 lb ft) |