LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2017 >> Envision Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Ignition Switch/Steering Lock >> Repair Instructions >> Repair Instructions >> Battery Distribution Engine Compartment Fuse Block Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Junction Block And Tabs
    GM3910776Courtesy of GENERAL MOTORS COMPANY
  1. Position the junction block and tabs (1) to the battery.
    2. Fig 2: Battery Positive Junction Block Cable Nut
    GM3910775Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Position the fuse block wiring harness terminals to the fuse block.
  3. Install the battery positive junction block cable nut (1) and tighten to 12 N.m (106 lb in).
  4. Install the fuse block wiring harness terminal nuts (2) and tighten to 4.7 N.m (42 lb in).
    5. Fig 3: Positive Battery Cable Nuts
    GM3910773Courtesy of GENERAL MOTORS COMPANY
  5. Install the positive battery cable (2) and tighten to 12 N.m (106 lb in).
  6. Install the small wire and positive battery cable nut (1) and tighten to 9 N.m (80 lb in).
    7. Fig 4: Starter And Generator Cable Nut
    GM3910758Courtesy of GENERAL MOTORS COMPANY
  7. Install the starter and generator cable.
  8. Install the starter and generator cable nut (1) and tighten to 12 N.m (106 lb in).
  9. Close the fuse block cover.
  10. Battery Negative Cable Disconnection and Connection - Install
scientia non olet · About LEMON Manuals