LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2017 >> Envision Essence, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System And Pedestrian Protection System >> Diagnostic Information and Procedures >> DTC B096C or B096D: Parking Assist Side Sensor Left/Right Front Circuit >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF for 30 s, disconnect the harness connector at the appropriate B94 Side Object Sensor - Front.
  2. Test for less than 10 Ω between the low reference circuit terminal 3 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF, disconnect the harness connector at the K182 Parking Assist Control Module.
    2. Test for less than 2 Ω in the low reference circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K182 Parking Assist Control Module.
    • If less than 10 Ω 
  3. Ignition ON, engine running.
  4. Test for 10.3 - 13.5 V between the 12 V reference circuit terminal 1 and ground.
    • If less than 10.3 V 
    1. Ignition OFF, disconnect the harness connector at the K182 Parking Assist Control Module.
    2. Test for infinite resistance between the 12 V reference circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the 12 V reference circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K182 Parking Assist Control Module.
    • If greater than 13.5 V 
    1. Ignition OFF, disconnect the harness connector at the K182 Parking Assist Control Module, ignition ON.
    2. Test for less than 1 V between the 12 V reference circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K182 Parking Assist Control Module.
    • If between 10.3 - 13.5 V 
  5. Test for 10 - 13.5 V between the signal circuit terminal 2 and ground.
    • If less than 10 V 
    1. Ignition OFF, disconnect the harness connector at the K182 Parking Assist Control Module.
    2. Test for infinite resistance between the signal circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K182 Parking Assist Control Module.
    • If greater than 13.5 V 
    1. Ignition OFF, disconnect the harness connector at the K182 Parking Assist Control Module, ignition ON.
    2. Test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K182 Parking Assist Control Module
    • If between 10 - 13.5 V 
  6. Test or replace the appropriate B94 Side Object Sensor - Front.
scientia non olet · About LEMON Manuals