Common Specs And Procedures Index
LACROSSE COMMON SPECS AND PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | APPROXIMATE FLUID CAPACITIES | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | First Pass
- 111 lb ft (150 N.m) Second Pass - Loosen 45 degrees Final Pass - 199 lb ft (250 N.m) |
||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | RIGHT REAR, LEFT REAR, RIGHT FRONT, LEFT FRONT. See HYDRAULIC BRAKE SYSTEM BLEEDING (MANUAL) See HYDRAULIC BRAKE SYSTEM BLEEDING (PRESSURE) |
||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Charging | |||
| Generator | N/A | ||
| Torque | 3.6L FASTENER SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | Serpentine belt used, not adjustable. | ||
| Drive Belt Routing | 3.6L - See the figure under DRIVE BELT REPLACEMENT . | ||
| Engine Cooling | |||
| General Service Specifications | N/A | ||
| Radiator Cap Pressure | Pressure stamped on cap. | ||
| Thermostat R & I | |||
| 3.6L | ENGINE COOLANT THERMOSTAT HOUSING REPLACEMENT (LGX) | ||
| Water Pump R & I | |||
| 3.6L | WATER PUMP REPLACEMENT (LGX) | ||
| 3.6L | |||
| Compression | The lowest reading should not be less than 70 percent of the highest reading. No cylinder reading should be less than 965 kPa (140 psi). See ENGINE COMPRESSION TEST |
||
| Oil pressure | Minimum @ Idle - 69 kPa (10 psi) Minimum @ 2, 000 - 138 kPa (20 psi) |
||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 3.6L 67 N.m (49 lb ft) |
||
| Fuel System | |||
| Pressure Specification (Ignition ON, engine OFF, command the Fuel Pump Enable On several times) | 3.6L Not Running - 345-690 kPa (50-100 psi) |
||
| Fuel Pressure Test Procedure | 3.6L - See CIRCUIT/SYSTEM VERIFICATION . | ||
| Fuel Filter Location | 3.6L - Fuel filter is part of the fuel tank fuel pump module. | ||
| Fuel Filter R & I | 3.6L See FUEL TANK FUEL PUMP MODULE REPLACEMENT (AWD) or FUEL TANK FUEL PUMP MODULE REPLACEMENT (FWD) . |
||
| Ignition | |||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | 3.6L - Individual Ignition Coil/Module Assemblies. | ||
| Ignition Wires (Routing) | |||
| 3.6L | Coil on plug. | ||
| Spark Plug | |||
| 3.6L (Refer to Electronic Parts Catalogue for Spark Plug Type) | |||
| Gap | 0.035 in (0.90 mm) | ||
| Torque | 13 lb ft (18 N.m) | ||
| Starting | |||
| Starter | 3.6L - N/A | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 111 lb ft (150 N.m) For tightening sequence, please see Wheel Nut Tightening Sequence figure under INSTALLATION PROCEDURE . |
||