Common Specs & Procedures Index
REGAL COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | Approximate Fluid Capacities | ||
| Torque | Fastener Specifications | ||
| Axle Nut/Hub Nut (Front) | |||
| First Pass | 111 Ft. Lbs. (150 N.m) | ||
| Second Pass | Loosen 45 degrees | ||
| Final Pass | 184 Ft. Lbs. (250 N.m) | ||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | RR, LR, RF, LF Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) |
||
| Disc Brakes | |||
| Service Specifications | Disc Brake Component Specifications | ||
| Torque | Fastener Specifications | ||
| Charging | |||
| Generator | CHARGING SYSTEM TEST | ||
| Torque | FASTENER SPECIFICATIONS (LTG) or FASTENER SPECIFICATIONS (LGX) | ||
| Drive Belts | |||
| Adjustment | |||
| 2.0L | Non-Adjustable Serpentine Belt | ||
| 3.6L | Non-Adjustable Serpentine Belt | ||
| Drive Belt Routing | |||
| 2.0L | See Graphic under Drive Belt Replacement | ||
| 3.6L | See graphic under Drive Belt Replacement (LGX) | ||
| Engine Cooling | |||
| General Service Specifications | NA | ||
| Radiator Cap Pressure | Pressure rating is shown on the pressure cap. | ||
| Thermostat R & I | |||
| 2.0L | Engine Coolant Thermostat Housing Replacement (2.0L LTG) | ||
| 3.6L | Engine Coolant Thermostat Housing Replacement (3.6L LGX) | ||
| Water Pump R & I | |||
| 2.0L 3.6L |
Water Pump Replacement (2.0L LTG)
, or Water Pump Replacement (3.6L LGX) N/A |
||
| Engine Mechanical | |||
| 2.0L | |||
| Compression | minimum compression in any 1 cylinder should not be less than 70 percent of the highest cylinder. No cylinder should read less than 690 kPa (100 psi). Engine Compression Test |
||
| Oil Pressure @700 RPM @ 100°C |
20-29 psi (140-200 kPa) | ||
| Overhaul | Engine Mechanical Specifications | ||
| Torque | Fastener Specifications | ||
| 3.6L | |||
| Compression | minimum compression in any 1 cylinder should not be less than 70 percent of the highest cylinder. No cylinder should read less than 690 kPa (100 psi). Engine Compression Test |
||
| Oil pressure Minimum - @1000 RPM @ 90°C (194°F) |
30-70 psi (206.84-482.63 kPa) | ||
| Overhaul | Engine Mechanical Specifications | ||
| Torque | Fastener Specifications | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | |||
| 2.0L A/T | |||
| First Pass | 15 lb ft (20 N.m) | ||
| Second Pass | 22 lb ft (30 N.m) | ||
| Final Pass | additional 40 degrees | ||
| 3.6L | |||
| First Pass | 30N-m (22 lb ft) | ||
| Final Pass | Additional 45 Degrees | ||
| Fuel System | |||
| Pressure Specification | Key on Engine Off Fuel Pressure Sensor Reading 50-94 psi (345-650 kPa) Engine Running Fuel Pressure Sensor Reading 43-58 psi (300-400 kPa) |
||
| Fuel Pressure Test Procedure | |||
| 2.0L | Circuit/System Verification (LTG) | ||
| 3.6L | Circuit/System Verification (LGX) | ||
| Fuel Filter Location | Fuel filter is an integral part of the in-tank fuel pump module. | ||
| Fuel Filter R & I | 2.0L Fuel Tank Fuel Pump Module Replacement (AWD) 2.0L Fuel Tank Fuel Pump Module Replacement (FWD) 3.6L Fuel Tank Fuel Pump Module Replacement (LGX) |
||
| Ignition | |||
| Firing Order & Cylinder Identification | |||
| 2.0L & 3.6L | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Engines have coil-on-plug ignition. | ||
| Ignition Wires (Routing) | Engines have coil-on-plug ignition. | ||
| Spark Plug | |||
| 2.0L (Type = Refer to Electronic Parts Catalog) | |||
| Gap | If using NEW spark plugs do NOT attempt to check gap or damage can occur, plugs come pre gapped. 0.037-0.043 In. (0.95-1.10 mm) | ||
| Torque | 15 Ft. Lbs. (20 N.m) | ||
| 3.6L (Type = Refer to Electronic Parts Catalog) | |||
| Gap | If using NEW spark plugs do NOT attempt to check gap or damage can occur, plugs come pre gapped. 0.030-0.035 In. (0.75-0.90 mm) | ||
| Torque | 13 Ft. Lbs. (20 N.m) | ||
| Starting | |||
| Starter | NA non-repairable starter motor | ||
| Torque | FASTENER SPECIFICATIONS (LTG) or FASTENER SPECIFICATIONS (LGX) | ||
| Wheel Alignment | |||
| Adjustment Specifications | Wheel Alignment Specifications (4-Door Hatchback 68) , or Wheel Alignment Specifications (4-Door Station Wagon 35) | ||
| Torque | Fastener Specifications | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 111 Ft. Lbs. (150 N.m). See Wheel Nut Tightening Sequence illustration under Installation Procedure | ||