Calibration (without UGN)
Do NOT swap cameras between vehicles, it is not approved and a VIN mismatch will occur.
The calibration process for the front view camera system is necessary when a front view camera module is replaced by a new one. This process is required anytime the module is removed from it's bracket and the frontview camera module has been mounted again properly. This process shall be completed within 3 - 5 minutes when the correct driving conditions are met. If conditions are not met, the front view camera module shall continuously run the service point calibration until successfully completed. This process shall work across ignition cycles and shall not be required to be re-initialized at start up. If the Lane Departure Warning Switch is pressed during calibration, the indictor will flash momentarily and then stay out - this is normal operation.
The calibration procedure may start automatically after SPS programming is complete. During this time the Lane Departure Warning amber indicator will illuminate.
To calibrate the front camera, operate the vehicle in the following conditions until the calibration is complete:
- Clean windshield.
- Avoid lane changes.
- Maintain vehicle speeds between 56 - 90 km/h (35 - 56 MPH).
- Ensure the road contains visible references (well defined lane markings, curbs, etc.).
Once the procedure is complete, the amber indicator will turn off. Shortly after the green ready to assist light should turn on as long as all conditions are met for normal operation. The system is then ready to assist.