Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connectors.
Reposition the instrument carrier to install the communication interface module bracket.
Communication Interface Module Bracket (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Communication Center Call Transceiver Bracket Bolt (1) - Install and tighten 2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Communication Interface Module Bracket Bolt (1) - Install and tighten [2x] 2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Compartment Bolt (1) - Install and tighten [2x] 2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Instrument Carrier Bolt (1) - Install and tighten 2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Knee Bolster Bolt (1) - Install and tighten 2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Install the right side instrument panel center lower bracket (2). Instrument Panel Center Lower Bracket Replacement
Courtesy of GENERAL MOTORS COMPANY

Serial Data Gateway Bracket (2) - Install - Serial Data Gateway Bracket Replacement
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Center Trim Plate Applique (1) - Install - Instrument Panel Lower Center Trim Plate Applique Replacement
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Center Air Outlet (2) - Install - Instrument Panel Center Air Outlet Duct Replacement
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Rear Air Duct-Front (2) - Install - Front Floor Console Rear Air Duct Replacement (Front)Front Floor Console Rear Air Duct Replacement (Rear)Front Floor Console Rear Air Duct Replacement (CJ4 Rear)
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console (3) - Install - Front Floor Console Replacement