Common Specs And Procedures Index
LACROSSE COMMON SPECS AND PROCEDURES
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | Approximate Fluid Capacities | |||
| Torque | Fastener Specifications | |||
| Axle Nut/Hub Nut | ||||
| Front | First Pass
- 111 lb ft (150 N.m) Second Pass - Loosen 45 degrees Final Pass - 199 lb ft (250 N.m) |
|||
| Battery | NA | |||
| Brakes | ||||
| Bleeding Sequence | RIGHT REAR, LEFT REAR, RIGHT FRONT, LEFT FRONT. See Hydraulic Brake System Bleeding (Manual) See Hydraulic Brake System Bleeding (Pressure) |
|||
| Disc Brakes | ||||
| Service Specifications | Disc Brake Component Specifications | |||
| Torque | Fastener Specifications | |||
| Charging | ||||
| Generator | N/A | |||
| Torque | 3.6L Fastener Specifications | |||
| Drive Belts | ||||
| Adjustment | Serpentine belt used, not adjustable. | |||
| Drive Belt Routing | 3.6L - See the figure under Drive Belt Replacement . | |||
| Engine Cooling | ||||
| General Service Specifications | N/A | |||
| Radiator Cap Pressure | Pressure stamped on cap. | |||
| Thermostat R & I | ||||
| 3.6L | Engine Coolant Thermostat Housing Replacement (LHN) | |||
| Water Pump R & I | ||||
| 3.6L | Water Pump Replacement (LGX) | |||
| 3.6L | Water Pump Replacement (LHN) | |||
| Compression | The lowest reading should not be less than 70 percent of the highest reading. No cylinder reading should be less than 965 kPa (140 psi). See Engine Compression Test |
|||
| Oil pressure | Minimum @ Idle - 69 kPa (10 psi) Minimum @ 2, 000 - 136 kPa (20 psi) |
|||
| Overhaul | Engine Mechanical Specifications | |||
| Torque | Fastener Specifications | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |||
| Flywheel/Flex Plate/Drive Plate Torque | 3.6L 67 N.m (49 lb ft) |
|||
| Fuel System | ||||
| Pressure Specification (Ignition ON, engine OFF, command the Fuel Pump Enable On several times) | 3.6L Not Running - 345-690 kPa (50-100 psi) |
|||
| Fuel Pressure Test Procedure | 3.6L - See Circuit/System Verification . | |||
| Fuel Filter Location | 3.6L - Fuel filter is part of the fuel tank fuel pump module. | |||
| Fuel Filter R & I | 3.6L See Fuel Tank Fuel Pump Module Replacement (AWD) or Fuel Tank Fuel Pump Module Replacement (FWD) . |
|||
| Ignition | ||||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Ignition Wires (Resistance) | 3.6L - Individual Ignition Coil/Module Assemblies. | |||
| Ignition Wires (Routing) | ||||
| 3.6L | Coil on plug. | |||
| Spark Plug | ||||
| 3.6L (Refer to Electronic Parts Catalogue for Spark Plug Type) | ||||
| Gap | 0.035 in (0.90 mm) | |||
| Torque | 13 lb ft (18 N.m) | |||
| Starting | ||||
| Starter | 3.6L - N/A | |||
| Torque | Fastener Specifications | |||
| Wheel Alignment | ||||
| Adjustment Specifications | Wheel Alignment Specifications | |||
| Torque | Fastener Specifications | |||
| Wheel & Tire | ||||
| Wheel Lug Nut Torque | 103 lb ft (140 N.m) For tightening sequence, please see Wheel Nut Tightening Sequence figure under Installation Procedure . |
|||