Circuit/System Verification
WARNING: This page is about a different car, the 2018 Buick Regal TourX and 2018 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC B384A 02 is not set.
- If the DTC is set
Refer to: DTC B384A
- Go to next step: If the DTC is not set
- If the DTC is set
- Perform the scan tool control function: Liftgate Open/Close - Open & Close
Verify the correct operation: Power Liftgate (TB5) = Full Open & Close
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- All OK.