Fastener Specifications
WARNING: This page is about a different car, the 2018 Buick Regal TourX and 2018 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Front Bolt | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
| Front Lower Control Arm Rear Bolt | Torque mating fastener |
| Front Wheel Bearing and Hub Assembly Bolt | |
|
100 N.m (74 lb ft) |
|
60 - 75 degrees |
| Steering Knuckle Bolt@Strut Assembly | Torque mating fastener |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Rear Nut | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
| Front Stabilizer Shaft Insulator Clamp Bolt | 22 N.m (16 lb ft) |
| Front Stabilizer Shaft Link Nut | 100 N.m (74 lb ft) |
| Front Suspension Strut Mount Bolt | 35 N.m (26 lb ft) |
| Steering Knuckle Nut@Front Lower Control Arm | |
|
40 N.m (30 lb ft) |
|
120 - 135 degrees |
| Steering Knuckle Nut@Strut Assembly | |
|
100 N.m (74 lb ft) |
|
45 - 60 degrees |