Replace and Program Control Module Using Existing Rear Differential Assembly

To program a replacement control module, perform the following procedure:

NOTE:

Steps 1-3 must be performed BEFORE the old K47 Rear Differential Clutch Control Module is removed from the vehicle.

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Prepare the Control Module for Removal and follow the on-screen instructions.
3. Replace the K47 Rear Differential Clutch Control Module.
4. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Programming and follow the on-screen instructions.
5. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Setup and follow the on-screen instructions.
   NOTE:

   RPO G99 = Twin Clutch System

6. Clear DTCs.