Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (with UGN)
WARNING: This page is about a different car, the 2018 Buick Regal TourX and 2018 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing Front View Camera Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Setup (if this option is available)
and follow the on-screen instructions.
If reprogramming an existing module that was previously calibrated, calibration is not required. The module retains its calibration settings during reprogramming. If a new module was programmed the module alignment must be calibrated. Using a scantool, initiate the learn procedure for Frontview Camera Module. The scantool must remain connected and on the calibration screen during the entire process.
Refer to Front View Camera Module Learn .
NOTE:
After programming is performed, it is normal to have DTC B101E 4B set until calibration is complete.