Power Transfer Unit Intermediate Drive Shaft Components Installation
WARNING: This page is about a different variant/trim than selected.
Power Transfer Unit Intermediate Drive Shaft Components Installation
| Callout | Component Name |
|---|---|
| 1 | Power Transfer Unit Intermediate Drive Shaft |
| 2 | Power Transfer Unit Intermediate Drive Shaft Bearing Retaining Ring [ 2x ] |
| 3 | Power Transfer Unit Intermediate Drive Shaft Bearing Procedure Use a press and press tube to install the bearing to the power transfer unit intermediate drive shaft. |
| 4 | Power Transfer Unit Intermediate Drive Shaft Bearing Retainer |
| 5 | Power Transfer Unit Intermediate Drive Shaft Seal
CAUTION:
When replacing power transfer unit case seals, use appropriate GM tools along with a hydraulic press. Failure to do so may result in misalignment or damage to the seal and/or power transfer unit.
CAUTION:
Do not nick, scratch or damage the sealing surface. The sealing surface is a machined surface. Damage to the machined surface can cause leakage. Special Tools
Equivalent regional tools: Refer to Special Tools . |
| 6 | Power Transfer Unit Half Shaft Seal - O-Ring Procedure Install a NEW seal. |
| 7 | Power Transfer Unit Intermediate Drive Shaft Clip Procedure Install a NEW retainer. |