K194 Rear Gate Module Scan Tool Information
Rear Gate Module Scan Tool Data Parameters
| Parameter | System State | Expected Value | Definition |
|---|---|---|---|
| Operating Conditions: Ignition ON | |||
| Rear Gate Latch Neutral Switch Stuck | - | No | This displays Yes if the rear gate neutral switch is active while other liftgate latches are inactive |
| Rear Gate Latch Primary Switch Stuck | - | No | This displays Yes if the rear gate primary switch is active while other liftgate latches are inactive |
| Rear Gate Latch Unlatch Switch Stuck | - | No | This displays Yes if the rear gate unlatch switch is active while other liftgate latches are inactive |
| Rear Gate Latch Neutral Switch Signal | - | Valid | This displays Invalid if the rear gate neutral switch is inactive while other liftgate latches are active |
| Rear Gate Latch Primary Switch Signal | - | Valid | This displays Invalid if the rear gate primary switch is inactive while other liftgate latches are active |
| Rear Gate Latch Unlatch Switch Signal | - | Valid | This displays Invalid if the rear gate unlatch switch is inactive while other liftgate latches are active |
| Rear Gate Ajar | - | Closed/Ajar | This will display the state of the liftgate |
| Rear Gate Latch Unlatch Switch | - | Inactive | The scan tool displays Inactive or Active. This is the state of the latch unlatch switch depending upon if the liftgate is in the open position or closed position |
| Rear Gate Latch Primary Switch | - | Inactive | The scan tool displays Inactive or Active. This is the state of the latch primary switch depending upon if the liftgate is in the open position or closed position |
| Rear Gate Latch Neutral Switch | - | Inactive | The scan tool displays Inactive and will briefly display Activate as the liftgate latch releases or cinches. |
| Rear Gate Anti-pinch Sensor Voltage Raw Value | - | 3.7v | The scan tool displays the actual voltage on the liftgate object sensors circuit as measured by the rear gate module. |
| Rear Gate Pinch Sensor Active | - | Inactive | This parameter will change from Inactive to Active when the rear gate pinch sensor is pressed |
| Rear Gate Travel | - | Less than 5% - greater than 80% | This parameter will change from less than 5% when the liftgate is in the close position to greater than 80% when the liftgate is in the open position |
| Rear Gate Max Height Learned | - | Learned | This displays Yes if the maximum height has been programmed |