Common Specs & Procedures Index
COMMON SPECS & PROCEDURES
| SYSTEM | SPECIFICATION/PROCEDURE | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | Approximate Fluid Capacities | ||
| Torque | Fastener Specifications | ||
| Wheel Drive Shaft Nut | |||
| Front or Rear: | First Pass: 330 N.m (244 lb ft) Second Pass: Loosen 45° Final Pass: 270 N.m (199 lb ft) |
||
| Battery | Battery Inspection/Test , Battery Electrical Drain/Parasitic Load Test | ||
| Brakes | |||
| Bleeding Sequence | RIGHT REAR, LEFT REAR, RIGHT FRONT, LEFT FRONT Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) |
||
| Disc Brakes | |||
| Service Specifications | Disc Brake Component Specifications (JL9) or Disc Brake Component Specifications (J61) | ||
| Torque | Fastener Specifications | ||
| Charging | |||
| Generator | Charging System Test | ||
| Torque | Fastener Specifications | ||
| Drive Belts | |||
| Adjustment | Non-Adjustable Serpentine Belt | ||
| Drive Belt Routing | See Identifying Drive Belt Routing Figure Under Drive Belt Replacement | ||
| Engine Cooling | |||
| General Service Specifications | Specifications | ||
| Radiator Cap Pressure | Pressure Cap Testing | ||
| Thermostat R & I | |||
| Engine Coolant Thermostat Housing Replacement | |||
| Water Pump R & I | |||
| Water Pump Replacement | |||
| Engine Mechanical | |||
| Compression | Engine Compression Test | ||
| Oil Pressure - Minimum @ Idle: 10 psi (69 kPa) | Oil Pressure - Minimum @ 2000 RPM: 20 psi (138 kPa) | ||
| Overhaul | Engine Mechanical Specifications | ||
| Torque | Fastener Specifications | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flex Plate Torque | First Pass: 22 lb. ft. (30 N.m) Final Pass: Tighten additional 45° |
||
| Fuel System | |||
| Pressure Specification | 3.6L Ignition ON, Engine OFF - 50-94 psi (345-650 kPa) Engine at IDLE - 43-58 psi (300-400 kPa) |
||
| Fuel Pressure Test Procedure | Circuit/System Verification | ||
| Fuel Filter Location | Fuel Filter is Part of the Fuel Tank Fuel Pump Module | ||
| Fuel Filter R & I | Fuel Tank Fuel Pump Module Replacement (FWD) or Fuel Tank Fuel Pump Module Replacement (AWD) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | Firing Order & Cylinder Identification | ||
| Ignition Wires (Resistance) | Individual Ignition Coil/Module Assemblies | ||
| Ignition Wires (Routing) | Coil On Plug | ||
| Spark Plug - For application, see parts catalog | |||
| Gap | 0.0375-0.0433 in (0.95-1.1 mm) | ||
| Torque | 13 lb ft (18 N.m) | ||
| Starting | |||
| Starter | Starter Replacement (LFY) | ||
| Torque | Fastener Specifications | ||
| Wheel Alignment | |||
| Adjustment Specifications | Wheel Alignment Specifications | ||
| Torque | Fastener Specifications | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 140 lb ft (190 N.m) For Lug Nut Tightening Sequence, Please See the Figure Under Installation Procedure |
||