Central Control Module (CCM): Removal

Turn ignition switch to OFF position. Disconnect negative battery cable. Locate CCM in trunk, attached to back of rear seat. See Figure . Remove nuts securing CCM to plastic tray and remove CCM. Disconnect CCM harness connector C1, then harness connector C2. Remove CCM from vehicle. Remove fastener studs from CCM and transfer to new CCM.

NOTE: If CCM harness connector C2 is disconnected first, then reconnected last, no CCM DTCs will set.

NOTE: If replacing CCM with NEW CCM, program NEW CCM with PASS-Key II(R) ignition key code. See ANTI-THEFT SYSTEM article.