Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of EBCM & BPMV

Courtesy of GENERAL MOTORS CORP.

Clean the seal surface of the BPMV.
Install the EBCM (1) to the BPMV (2).
Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.

IMPORTANT: Use New EBCM/BPMV screws after separating the EBCM from the BPMV.

Fig 2: Installing Electronic Brake Control Module-To-Brake Pressure Modulator Valve Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the NEW EBCM to BPMV screws.
Tighten: Tighten the (4) NEW EBCM to BPMV screws in sequence (1-4) to 5 N.m (44 lb in).

Fig 3: View Of EBCM And Electrical Connector

Courtesy of GENERAL MOTORS CORP.

NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.

Connect the EBCM electrical connector (1) to the EBCM (3).
Rotate the EBCM connector tab (2) to the locked position.
Install the front air deflector. Refer to Air Deflector Replacement - Front in Body Front End.
Lower the vehicle.
Use the scan tool in order to clear the DTCs.
Perform the auto bleed procedure. Refer to ABS Automated Bleed Procedure .
If installing a new EBCM it is necessary to program the EBCM. Refer to Service Programming System (SPS) in Programming.
Perform the ABS Diagnostic System Check. Refer to Diagnostic System Check - ABS .
Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Replacement in Lighting.