Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Insulator Mounting Bolt To EBCM

Courtesy of GENERAL MOTORS CORP.

Clean the BPMV seal surface with alcohol using a clean rag.
Install the seal to the BPMV if it is not cut or damaged.
Install the EBCM to the BPMV.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the six mounting bolts in the following sequence:
Tighten:
- First pass to 3 N.m (27 lb in).
- Second pass to 6 N.m (53 lb in).

IMPORTANT: If the insulator nut was removed it must be replaced with a new insulator nut.

Install the front EBCM insulator mounting bolt.
Tighten: Tighten the bolt to 14 N.m (10 lb ft).

Fig 2: EBCM Harness Connector & Bracket

Courtesy of GENERAL MOTORS CORP.

Install the EBCM/BPMV into the bracket.
Install the two insulator nuts (1).
Tighten: Tighten the two insulator nuts to 12 N.m (106 lb in).
Connect the EBCM harness connector.
IMPORTANT: Both sides of the EBCM harness connector must be engaged with lever before closing.
Turn the ignition switch to the ON position; do NOT start the engine.
Perform the Diagnostic System Check - ABS .