Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Turn off the ignition switch.
- Open the center console door.
- Pull up on the rear of the switch assembly in order to release the mounting clips; if the switch does not release from the trim plate, perform the following steps:
- Carefully insert a screwdriver into the access hole located on the rear of the switch assembly.
- Gently pull up on the switch.
- Disconnect the harness connector (1).
- Remove the switch assembly (2).