Body Control Module: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the negative battery cable(s).

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




2. Remove the knee bolster.




3. Disconnect the brown connector.
4. Disconnect all other connectors (1).
5. Remove the BCM from the sliding bracket.

INSTALLATION PROCEDURE




1. Slide the BCM onto the bracket.
2. Connect all the connectors (1) except the brown connector.
3. Connect the brown connector.




4. Install the knee bolster.
5. Connect the negative battery cable(s).
6. Reprogram the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration. Programming and Relearning
7. Perform the Passlock Learn Procedure. Refer to Programming Theft Deterrent System Components in Theft Deterrent. Programming and Relearning