LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2005 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Engine Control System - 8.1L - Introduction) >> Repair Instructions >> Powertrain Control Module (PCM) Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of PCM
    GM814119Courtesy of GENERAL MOTORS CORP.
  1. Install the PCM.

    Ensure that the mounting tabs are engaged.

  2. Secure the spring latch to the PCM.
    3. Fig 2: View Of PCM Electrical Connectors & Bolts
    GM814117Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Connect the PCM electrical connectors.
  4. Tighten the PCM electrical connector bolts (2).

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

    5. Fig 3: View Of PCM Cover
    GM814118Courtesy of GENERAL MOTORS CORP.
  5. Install the PCM cover.

    Ensure the mounting tabs are engaged into the mounting holes in the cover.

  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  7. If a NEW PCM was installed, program the PCM. Refer to Control Module References in Computer/Integrating Systems.
scientia non olet · About LEMON Manuals