Method 2 - Service Programming System Fob Programming

This procedure is a 10-minute relearn procedure using the Techline Terminal with SPS software. A scan tool, Techline Terminal, and a replacement key fob are required to perform this procedure.

1. Place the vehicle in the Vehicle On, Engine Off mode.
2. Connect a scan tool to the vehicle.
3. Insure that all power consuming devices are turned OFF on the vehicle.
4. With a scan tool, select Request Info under Service Programming System and follow the scan tool on-screen instructions.
5. Disconnect the scan tool from the vehicle and connect the scan tool to a Techline Terminal with the current Service Programming System (SPS) software.
6. Turn the vehicle OFF.
7. On the Techline Terminal, select Service Programming System and follow the Techline Terminal on-screen instructions. Ensure the correct programming procedure is selected based on component being replaced or programmed. See Important above.
8. Disconnect the scan tool from the Techline Terminal and re-connect the scan tool to the vehicle.
9. With a scan tool, select Program ECU under Service Programming System.
10. At this point the scan tool must remain connected for the duration of the 10-minute relearn procedure.
11. When the 10-minute relearn procedure has completed, using the scan tool, access the following:
    • Vehicle Control Systems
    • Computer/Integrating Systems
    • Module Replacement/Setup
    • RCDLR
    • Program Key Fobs
12. Select Fob X (X = 1, 2, 3, or 4) on the scan tool. This will be the slot you wish to program to.
13. Place the replacement key fob in the glove box pocket with the buttons facing right. A beep will occur indicating programming completion. The previously known fob is now erased.
14. If programming additional key fobs, repeat steps 12-13, or press the OFF/ACC portion of the ignition switch to exit programming mode.
15. Remove the scan tool.
16. Operate the active portion of each key fob to finalize the programming and verify correct system operation.