Installation Procedure

Fig 1: View Of Remote Control Door Lock Receiver & Screws

Courtesy of GENERAL MOTORS CORP.

Connect the receiver connector and route the wire harness through the I/P carrier.
Line up the receiver with the hole on the retainer.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the retaining screws to the remote control door lock receiver.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement in Instrument Panel, Gages, and Console.
Perform the RCDLR programming and setup procedure. Refer to Control Module References for programming and setup information.