LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 1079 (Object Detection System) >> Diagnostic Information and Procedures >> DTC B0967 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the I/P multifunction switch assembly.
  2. Test for less than 1.0 ohm between ground circuit terminal 3 and ground.
    • If greater than the specified range, test the ground circuit for a short to voltage or an open/high resistance.
  3. Ignition ON, transmission in REVERSE, verify that the scan tool Park Assist System Status parameter is Enable.
    • If not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, test or replace the object alarm module.
  4. Connect a 10A fused jumper wire between signal circuit terminal 2 and ground.
  5. Ignition ON, transmission in REVERSE, verify that the scan tool Park Assist System Status parameter is Disable.
    • If not the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, test or replace the object alarm module.
  6. If all circuits test normal, test or replace the I/P multifunction switch assembly.
scientia non olet · About LEMON Manuals