Digital Radio Output Circuit Malfunction
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the X2 harness connector at the radio.
- Ignition ON, radio ON and tuned to XM, test for a varying mV AC voltage reading between the following signal circuit terminals listed below and ground.
- Left audio signal (+) - Connector X2, terminal 1
- Left audio signal (-) - Connector X2, terminal 9
- Right audio signal (+) - Connector X2, terminal 2
- Right audio signal (-) - Connector X2, terminal 10
- If the voltage reading is not as specified, test the signal circuit for a short to voltage, short to ground, or an open/high resistance. If the circuit tests normal, replace the DRR.
- If all circuits test normal, test or replace the radio.