Reprogramming the PTOM for Fast Idle/PTO Using the Scan Tool
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
A scan tool must be used to enable certain PTO options and also to adjust the factory preset parameters to the desired settings. The scan tool menu driven device is a hand held scan tool that plugs into the datalink connector located underneath the dash near the driver seat.
For additional scan tool information, refer to Control Module References .